The trick to determining whether or not a new alternator is required lies in testing. When the electricity
stops flowing, a common error is to assume that the battery is dead. You can replace it with a new one,
only to have it quickly discharge because the alternator had already breathed its last breath and is no
longer making electricity to charge up the battery. Conversely, one could replace a perfectly good
alternator when in fact it is the battery that has lost its ability to store electricity. A finicky voltage
regulator can also cause problems. The classic symptoms of a dying alternator are lights getting dimmer
and sluggish electrical accessories while driving around after dark.
This situation occurs because the alternator is no longer making enough electricity to run the show, and
the vehicle is drawing power off the slowly dying battery. If driven around long enough, the vehicle will
use up all the battery's electricity and everything will come to a halt. Since getting stranded at night is not
the world's best motoring experience, it pays off in the long run to maintain and check batteries, belts,
voltage regulators and alternators. The good news is that determining which part of the system is doing its
part and which part is a little tired or about to quit altogether is easier than ever. Many auto parts stores
now have portable diagnostic equipment that can sniff out in minutes what's going on with the electrical
system. If the alternator has gone out to lunch permanently, replacing it is usually a relatively easy job.
Follow along with the step-by-steps for some alternator replacement tips.
Step 1: Disconnect the battery negative. This is an especially important first step, as all the electricity for
the entire vehicle goes through the alternator. A wrench or a screwdriver across connectors can quickly
fry voltage regulators, expensive engine computers, and cause injury.
Step 2: On a v-belt vehicle there are usually two bolts holding an alternator to its mounts. One bolt or
assembly maintains tension on the belts, and the other holds the alternator in place. First loosen and
remove the tension bolt or assembly.
Step 3: Next, loosen the pivot bolt.
Step 4: Remove the pivot bolt. Remove electrical connections and slide the pivot bolt through the mount.
Remove the alternator. This is a good time to check and replace worn belts.
Step 5: Compare the old and new alternators to make sure everything is the same. Transfer any connectors
or bolts from the old to the new.
Step 6: Reverse the removal procedure and install the new alternator.
Step 7: Check belt tension. A little under an inch of deflection is ideal. Too much tension will quickly
destroy bearings. Better a slightly loose belt than one too tight.
Step 8: Start the vehicle and check alternator output with a multimeter.
Step 9: Re-check belt tension after about 500 miles. Adjust tension if required.
0 comments